Use the following troubleshooting table if you are encountering skipped stitches in your embroidery.
Problem Area |
Possible Causes |
Solutions |
Needles |
Needle is bent or damaged |
Replace with a compatible needle |
Incorrect needle for the thread size being used |
Replace with a compatible needle |
|
Needle depth |
Needle bar lowest dead point is incorrect |
Adjust needle depth (See Needle Depth Adjustment). |
Rotary hook |
Hook timing is incorrect |
Adjust hook timing (See Hook Timing Adjustment). |
Hook gap is too wide |
Adjust hook timing gap (Hook Timing Adjustment). |
|
|
Damaged/ bad hook |
Replace hook (Click here for instructions). |
Presser foot |
A weak or broken presser foot spring prevents the presser foot from lifting out of the fabric smoothly The presser foot height may not be adjusted correctly |
Replace the spring (Contact Melco Technical Support) Check Presser Foot Height |
Thread
|
Bad thread |
Use the appropriate thread or consult Melco Csutomer Service for suggestions. |
Thread feed roller |
Thread wore a groove in the roller |
Replace thread feed roller. Click here for instructions. |