The AC power input to the machine is fused at the power input switch/connector. There are two fuses located in the Power Input Switch between the power switch and the power input connector. The following troubleshooting chart will help you diagnose most AC power failure issues.
|
Step |
Symptom/Procedure |
Condition |
Solution/Step |
|
1 |
No AC power to the AMAYA. Nothing happens when the machine is turned on. |
Machine is not plugged in |
Plug in the machine power cord |
|
Machine is plugged in |
Go to Step 2 |
||
|
2 |
Check the power from the wallpower supply outlet |
No or low power from wallpower supply |
Troubleshoot the electrical wall outlet or contact a local electrician to make the repairs. |
|
Wallpower good |
Go to Step 3 |
||
|
3 |
Check the fuses located in the fuse block between the power input switch and the power input connector. |
Fuses bad |
|
|
Fuses good |
Go to Step 4 |
||
|
4 |
Conduct power supply test to verify condition of power supply assembly. |
No 36V output from power supply but power input is good |
|
|
No or low AC input to Power Supply Unit |
|||
|
Intermittent failure in power input to Power Supply Unit |
|
||
|
Power Supply good |
Go to Step 5 |
||
|
5 |
Remove the base cover and observe the LEDs on the main PCB. |
5V LED at location D43 off, 15V LED at location D32 off |
|
|
No LEDs flashing |
|||
|
LEDs all operating properly |
Go to Step 6 |
||
|
6 |
Above steps do not detect the problem. |
|
Contact Melco Technical Support |
