Error Code 0001001E
This error indicates a table/platen movement problem. The error is most commonly caused when the user presses the flashing green button "before" the printer is in the READY state OR has not been pressed at all before attempting to start a print job. This will result in a lockup of the printer control panel.
The Error Occurs during Start Up
Cycle machine power
- Press the power button in and release it to the "Off" position.
- Remove the power cord from the back of the machine.
- Install the power cord back in the machine.
- Press the power button in on the control panel to turn the printer back on and allow the normal machine initialization to begin.
- When the display reads READY press the flashing green button to allow machine initialization to complete.
Re-seat the PF Encoder Sensor
- Turn off the machine power
- Remove the machine power cord
- Remove the rear machine cover
- Remove the PF Encoder Cover
- Unplug the PF Encoder cable from the Encoder Sensor
- Plug the PF Encoder Cable back in to the Encoder Sensor
- Replace the covers
- Install the power cord
- Press the power button in on the control panel to turn the printer back on and allow the normal machine initialization to begin.
- When the display reads READY press the flashing green button to allow machine initialization to complete.
- Test machine Table Tray movement
The Error Occurs During or After Printing
- Select the Paper Roll Icon without the scissors at the Epson display
- Check the platen/table size in the MelcoRip software
- Verify All printer settings are correct
- Verify that the Table Tray does not actuate the front limit switch
Clean the Encoder Strip and Sensor
Check the guide rails and the guide rollers
- Ensure that there is nothing obstructing the movement of the table on the rails
Change the Encoder Harness